INFORMATION
Let the spray mixture sit for a maximum of 8 hours. After that, it is no longer usable.
-
Make sure the pump is switched off.
-
Set the valves in Cleaning Spraying System position mode.
INFORMATION
Do not use this 3D illustration as reference. Refer to the position modes table.
-
Start the pump.
-
On the app, activate Flushing mode.
-
Spray approximately 20 L | 5.3 US gal on an untreated area.
-
Turn off the pump.
-
Remove and clean the suction filter and the section filter (Cleaning).
-
When treatment is resumed, set the agitation valve to HIGH + LOW zone and shake for 10 minutes (Agitation).
