Tank system
|
Water tank volume |
140 L 37 US gal |
|
Mixture tank volume |
140 L 37 US gal |
|
Induction hopper volume |
20 L 5.3 US gal |
|
Overpressure limit |
8 bar 116 psi |
|
Pressure in the booms
|
3 bar 43.5 psi |
|
Broadcast flow rate at 7 km/h |
400 L/ha 42.8 US gal/ac |
|
Typical work rate |
Up to 1.6 ha/h Up to 4 acres/h |
Filters
|
Water tank filter basket |
18 mesh |
|
Mixture tank filter basket |
18 mesh |
|
Suction filter |
80 mesh |
|
Section filter |
100 mesh |
Spray booms
|
Number of boom |
2 booms |
|
Effective number of nozzles |
108 nozzles |
|
Total spray width |
2.22 m 7.3 ft |
|
Flow of all booms in full |
21.6 L/min 5.7 US gpm |
Nozzles
|
Single nozzle broadcast flow rate at 3 bar |
0.2 l/min 6.76 fl oz/min |
|
Spray angle (As) |
25° |
|
Spray geometry |
Flat triangle |
|
Orifice diameter (Do) |
0.46 mm |
Brand and type of nozzles: Euspray type IC1X502E
Residual volume
The total residual volume is defined in ISO 13440:1996 §2.1. It is the sum of the volume of the residue in the tank (dilutable volume) and the dead volume (non-dilutable volume). The maximum allowable value of this volume is defined in ISO 16119-2:2013 §5.1.1.3.1. The boom width taken into account is the total width used for spreading by cumulating the overlaps. This width is X m | X ft and is therefore wider than the projected with of X m | X ft.
|
Mixture tank volume (Vb) |
140 L 37 US gal |
|
Total spraying width (Lb) |
2.22 m 7.3 ft |
|
Volume of total allowable residue (Vr = 0.5 % Vb + 2 Lb) |
5.14 L 1.4 US gal |
Mechanical values
|
Forward speed |
2.0 m/s 6.56 ft/s |
|
Minimum forward speed |
0.6 m/s 2.13 ft/s |
|
Maximum water mass
|
155 kg 341.7 lbs |
|
Maximum spray mixture mass |
140 kg 308.6 lbs |
|
Sprayer mass (empty tanks) |
760 kg 1 675 lbs |
|
Sprayer mass (full tanks) |
1055 kg 2 326 lbs |
|
Tire pressure |
1.0 bar 14.5 psi |
Tractor configuration requirements
|
Hitch |
The machine is suitable for tractors equipped with a standardized category 1 three-point hitch |
|
Rear lifting capacity at 610 mm from the hitch |
1100 kg 2425 lbs |
|
Minimum distance from the end of the PTO to the center of the lower hitch point (with the lower link horizontal) (Lmin) |
0.5 m 1.6 ft |
|
PTO power |
2.5 kW 3.35 hp |
|
PTO rotation frequency |
540 rpm (for units before September 2026) 350-400 rpm (do not exceed 450 rpm) (for units from September 2026) |
Tractor to ALBA™ connection requirements
IMPORTANT
Compatibility of the tractor's electrical system must be confirmed by an Ecorobotix official dealer before installation. Any required electrical connections or modifications must be carried out by an Ecorobotix official dealer. Do not attempt to install or modify the electrical connection yourself. Ecorobotix shall not be held responsible for damage or malfunctions resulting from incorrect installation or unauthorized modifications.
|
Parameter |
Requirement |
|---|---|
|
Alternator |
Compatible with ALBA charging system |
|
Electrical connector |
DIN 9680 |
|
Maximum continuous current |
25 A |
|
Ignition-switched wire |
12 V DC when the ignition is ON (KEY 15 - FUSE). Must be protected by a 1–10 A fuse (not supplied). |